Saturday, July 11, 2026

Conditions for the equipment of thermal energy wells

Well equipment must guarantee the implementation of the main technological and technical and economic solutions included in the well site development project.

The design of wellhead equipment for thermal power wells should have the following factors:

- volume of production fluid;

- reservoir pressures;

- fluid temperature;

- probability of salt precipitation;

- corrosiveness of the fluid;

- connection with pipes in diameter.

Depending on the water intake conditions, the equipment can be standard or individual.

In addition to technological compatibility and compliance with occupational health and safety requirements, the equipment of thermal power wells must provide measurements of temperature and pressure of fluid flow rates. 

Increased attention should be paid to flanged and threaded connections in the well shut-off valves, in the use of which corrosive elements can be observed.

The system of control and safety monitoring of the operation of well equipment should concern:

- time of working flows;

- wellhead pressure;

- temperature regime;

- chemical and gas composition of water;

- sand level;

- salt deposition.

Operational systematic observation is facilitated by constant research, which is divided into:

- current;

- control;

- special.

Current studies are conducted to identify the technological mode of operation, check the parameters of the reservoir zone and well.

Control studies are conducted according to plan and are aimed at clarifying data from current studies.

Special studies serve to identify individual factors that affect the water capacity and operating conditions of wells and their locations as a whole.

No comments:

Post a Comment

Design of pilot-industrial field development

Based on the approved technological indicators for the field development, project documents are prepared for its development (up to 5 years)...