The main conditions for subsoil protection when implementing various measures aimed at increasing well productivity by affecting the near-wellbore area are:
- preserving casing strings;
- preserving the integrity of the cement ring;
- prevention of formation collapse in the near-wellbore area;
- preventing the expected dehydration of the well and artificial gas deposit as a result of individual layer exploitation.
It is forbidden to carry out intensification work on technically faulty wells when there is a danger of gas crossflow between layers and loss of sealing in the annular space.
It is not allowed to carry out well stimulation work in wells where the natural separation between gas-bearing and water-bearing layers is small.
If before working on the near-face zone of the seam there was no disturbance of the seam structure or rock displacement, but after the work there was penetration into part of the rock, you need to stop using the well.
The well is equipped with a filter.
Intensification measures should be carried out after conducting experimental studies in order to obtain data on process parameters.
The design, number, and location of absorption wells for discharging and disposing of industrial waste are determined by the process map and its appendices.
Absorption wells, regardless of their location, must be gas-tight and tested at the storage operating pressures.
In case of wellbore blockage and loss of connection with the formation, measures should be taken to restore the well.
When leaks are detected through wellhead equipment and flange connections, wells need to be shut down and the leaks eliminated.
All measures to eliminate leaks and improve the tightness of the column should be taken immediately after defects are detected.
At the same time, it is necessary to identify the composition of the gas and the direction of flows if leaks are detected at the control horizons.
Based on the obtained data, a program for repairing defective wells and an assessment of repair and restoration measures should be prepared.
No comments:
Post a Comment